The Compucage T Series

The T1000 fits computers that are 9.5" to 14.5" high and is ideal for small towers.

The T2000 fits computers that are 14.5" to 21" high and is ideal for mid sized towers.

The T3000 fits computers that are 19.5" to 26" high and is ideal for servers.

The Compucage T Series is designed to accommodate most servers and desktop computers. Using a simple but elegant design, the T Series will provide you with a reliable and affordable security solution.

- The T Series are simple to install and can be secured on the base or through a side mount.

- The T Series can also be secured with a L-Shaped adaptor plate accessory.

- The T Series will not restrict air flow or access to the cables.

The Compucage F Series

The F1000 fits form factor that are 12.5" to 17" high and a maximum base dimension of 17" by 4.25"

The Compucage F1000 is designed to secure your form factor against theft. Using a simple but elegant design, the F1000 will provide you with a reliable and affordable security solution. The Compucage F1000 is designed not to restrict air flow or access to the cables.

Tower Installation Instructions

STEP 1 - First of all, ensure that you have the right size of Compucage for your computer.

STEP 2 - Then ensure that you have all the parts identified in the picture to the left. Your Compucage comes with a set of 3 keys. Keep these in a safe place, away from the computer.

(Installation Option A)

STEP 3 - Select a suitable and convenient location for your computer and place the two pieces of the base plate where you want the computer to be locked to the floor or work surface

Adjust both parts of the stand to accommodate the computer snugly, remove the computer and mark the "hole positions" on the floor or work surface.

Drill four holes in the floor or work surface and bolt the stand in place. One hole should be located at the front and back of each stand.

STEP 4 - Slide the adjusting bar into the top housing as shown. Rotate one of the now connected locating bars to fix them in a uniform upright position. You can also adjust the distance between the locking bar and locating bar to fit securely around the sides of the tower by this same manoeuvre.

STEP 5 - Place the computer on the stand and slide the bars together over the computer into both the lock assembly and opposite side retaining hole.

STEP 6 - Push in the top bar until it is a snug fit over the computer and lock the bar in place with your key.

(Installation Option B)

Note: As an alternative, you can bolt the cage bar (on the side away from the lock) to a vertical section of a wall, desk or table. Bolt unit down to a sub surface first.

This additional part (Mounting Bracket) is an optional accessory.

Lock system by turn key. Keep keys in a safe place away from your computer.